Installing the components

      This section indicates how to install some of the Solution-Pac / WAN software components ( UM-Agent , UM-Client , UM-Console + ) on a IBM OS/2 computer.

      Before proceeding with the installation, we assume that you have read the installation Pre-requisites .

      If you use UM-Agent start by installing the components on THE computer CONNECTED DIRECTLY to the UPS.

      If you are on THE computer CONNECTED DIRECTLY to the UPS, at the same time as UM-Agent, you must also install UM-Client to protect it.

      We recommend to you not to install UM-Console+ on the same computer as UM-Agent because Windows emulation requires a lot of CPU ressources.

      Important:
      OS2 2.x and OS2 Warp Connect require       specific configuration to enable RS232 port.

      Follow these steps to install Solution-Pac / WAN components :

      • Insert the CD-ROM in the drive.
      • If the welcome screen does not appear automatically, select the Run option from the task bar and enter <DRIVE_NAME>:\STARTUP
      • The Solution-Pac CD-ROM welcome screen appears. Choose the « language », « accept the conditions », then click on « installation » and follow the instructions displayed on screen:
        Remark: This section of the documentation follows the various installer steps. You can also consult the documentation at the same time as you carry out the installation. Reactivate the Solution-Pac CD-ROM welcome screen ("Alt" "Tab" keys) then select "Documentation".
      • There are two types of installation:
        Personal Solution-Pac
        Solution-Pac / WAN
         Choose Solution-Pac / WAN to install the components described in this documentation.
      • A screen is displayed. You must select the Solution-Pac / WAN components you want to install on the target computer according to the architecture you have chosen:
        - UM-Agent communicates with the UPS.
        - UM-Client protects the system.
        - UM-Console monitors the UPS (install UM-Console + on another computer than UM-Agent)
      • A screen prompts you to enter the parameters of the components installed chosen to communicate between the computer and the UPS.
      • You can start the installed components by clicking on the "Start" button of the screen that prompts you and you can remove the CD-ROM from the drive after exiting the Solution-Pac welcome navigator screen.
      • If you are on THE computer directly connected to the UPS, you must test UM-Agent
      • You must test UM-Client.
      • If you have installed and tested the components required to protect this computer, the protection is now active on this computer and will be run automatically on each startup.
      • Install UM-Client on the other computers to be protected.

      IMPORTANT: If you stop the embedded agent or the computer UM-Agent was installed on, no other computer will be protected.